Select Language

Removing the Camera from a SeeSnake Camera Reel

Read this article to learn how to remove the camera from a RIDGID® SeeSnake® camera reel.

Steps

  1. Snap the included spanner wrench onto the spring, just behind the camera.
Snapping the spanner wrench onto the spring
  1. Align the notch inside the spanner wrench with the end of the spring coil.
Aligning the spanner wrench with the spring coil
  1. Unscrew the spring from the camera.
Unscrewing the spring from the camera
  1. Unscrew the locking sleeve from the camera.
Unscrewing the locking sleeve
  1. Pull the camera straight out of the sonde’s socket. To avoid damaging the camera’s connector pins, do not bend or twist while pulling the camera out of the connector.
Pulling the camera out of the socket

Pan and Zoom on CSx Monitors

Panning and Zooming is a helpful way to highlight areas of interest within the image displayed on a CSx device.

SeeSnake Pro

Introducing the new RIDGID SeeSnake Mini Pro, our smallest and most rugged self-leveling camera, equipped with TruSense® technology.

Clamshell Kickstand Instructions

Follow these instructions to learn how to set up your kickstand for the RIDGID® SeeSnake® microDrain™, microReel™, and nanoReel™ systems.

SeeSnake Tips & Tricks

Watch this video to learn tips and tricks on getting the most out of your SeeSnake camera reel during a pipe inspection.

Adding Inspector Information

How to save default inspector information to a RIDGID SeeSnake inspection monitor so you can quickly add it to reports.

Copyright © SeeScan. All rights reserved.

 Legal
Go to Top